A roof coating is a liquid, usually white, rolled or sprayed over a clean roof to seal it and reflect sun. It can extend the life of a sound but worn flat or metal roof. Call the number on this page to be connected with a local roofing contractor in Porter.

Telling coated from uncoated
A previous coat may show as a thick, rubbery, sometimes peeling layer, often white or silver. A fresh coat must bond to it. Peeling old coating needs removal or a test patch. Share anything you know about earlier work.
UV, heat and chalking
Sun is the main enemy. Coatings stand between it and the roof, taking the wear themselves. Over years they chalk and thin, and a recoat may be needed. A roofer can tell you what thickness is applied and how often to look at it.
Rural metal buildings and barns here often suit coatings, and unincorporated land has no city permit review, though lenders and insurers may ask questions.
Energy savings and claims
Reflective coatings can lower cooling demand, but results vary with insulation and building use. Be careful of promises about exact savings. Ask what basis a roofer has for any estimate and request it in writing. Savings depend heavily on how the building is used.
Before you call in Porter
Permit note from the Montgomery County Permitting office: The county does not require a permit for a roof, though an HOA or POA may have its own rules.
If insurance is paying, know that Texas law bars a roofer from waiving, rebating or covering your deductible, and a roofer who is doing the work can't also negotiate your claim as an adjuster.
Hurricane season runs June 1 through November 30. Lifted tabs, loose ridge caps and missing shingles are worth a look after any strong blow.
Tall pines around Porter drop needles that fill valleys and gutters and keep parts of the roof shaded and damp.
Storm took out power too? Report it to Entergy Texas at 800-968-8243, and stay clear of any downed line.
Nearby, the same kind of help is available in Spring, Kingwood and New Caney.
How a coating job goes
- Pressure wash or clean the roof
- Repair splits, seams and flashings
- Apply primer where needed
- Roll or spray the first coat
- Add a second coat once the first is dry
- Check edges and penetrations at the end
Keep drains and gutters clear
Debris holds water against the coating and speeds failure. From the ground, check for clogged scuppers and downspouts. Ask the roofer to clear them before work begins, and do not lean ladders on edge metal, which can bend under the weight and open the seam.
Roof Coating questions in Porter
Will a reflective coating cool my building?
Why do coatings peel?
Does coating help against hurricane wind?
Does coating need a permit?
More roofing services in Porter
Roof Coating nearby
Helpful guides
Sources
Last updated: